All data is for information only------(<---links)
	PRODUCT DATA of Sheldahl 146383

Material	Sheldahl 146383
General Information	Previously G400900
Product Type	Thermal-control plastic film.
Chemical Composition	Fluorocarbon (FEP), Aluminised.
Name of Manufacturer	Sheldahl sheldahl.info@sheldahl.com www.sheldahl.com 150 Sheldahl Rd., Northfield, MN 55057, USA +1 507 663 8000 +1 507 663 8545

	EXPERIENCE IN PRACTICE

Development Status	Special Commercial Product
Cost Range	High
Lot Reproducibility	Good
Space Experience	Good

	PHYSICAL PROPERTIES

Specific Gravity	2.15 Data Quality: Manufacturer's data
Standard Width	122 mm Data Quality: Manufacturer's data
Thickness	0.127 mm Data Quality: Manufacturer's data

	ELECTRICAL PROPERTIES

Electrical surface resistance	1e16 ohm Remark:ASTM D257-61
Electrical Volume Resistivity	1e16 ohm.m Remark:ASTM D257-61
Dielectric Strength	138 kV/mm Remark:(of FEP film) 25°C, 60Hz

	THERMAL PROPERTIES

Thermal Conductivity	0.194 W/m.K Data Quality: Manufacturer's data
Thermal Expansion Coefficient	83 μstrain/°C Data Quality: Manufacturer's data
Specific Heat	1.17 J/g.K Data Quality: Manufacturer's data

	OPTICAL PROPERTIES

Thermal Emittance	0.77 Test:ECSS-Q-70-09
Solar Absorbtance	0.13 Test:ECSS-Q-70-09

	RELEVANT PROPERTIES FOR USE IN SPACE COMMUNITY

Toxicity/Offgassing	Pass Test: NASA NHB 8060-1A
Temperature Range(space)	-185 to +150°C Test: Long term
Outgassing	RML = 0.05% CVCM = 0.01% Test: ECSS-Q-70-02
Oxygen Index	95 Test: ECSS-Q-70-21
Moisture Absorption	< 0.01% Test: DuPont’s Data

	SPECIAL RECOMMENDATIONS

Special Recommendations

There exist thinner films of the same material: 50micron 146377 (G.400500), 25micron 146416 (G402000) and also thicker; 254micron 146434 (G403800). Other widths than standard can be obtained. · There exist similar films with incorporated adhesive, either acrylic pressure sensitive, suitable for space, or silicones of which the suitability is doubtful. It is anyway preferable to fasten the film on a separately applied double-sided adhesive tape in order to avoid crazing in the metal layer due to the peeling off of the liner. · The nomenclature of the Sheldahl company can be confusing and identification of films must be known very precisely for each type used. · Depending on the adhesive used, Sheldahl aluminised FEP may be damaged by thermal cycling according to ECSS-Q-70-04. · Perforated versions of the film are available. Perforation is recommended for space use · Electrically conductive versions are also made by Sheldahl (front layer ITO deposit). However, conductivity is not maintained during wide temperature band of thermal cycling and ITO layer is degraded by long-term exposure to RH > 60%. · Protective overlay is available.